I finally got all the units in and attached to the van. The units are screwed to the wall battons with right angle brackets, bolted together and also screwed into the floor. The last thing I want is for the units to get loose when driving.
You can see here the units/ sink/Worktop in place.
Next I needed to seal the 3 holes I drilled through the floor to prevent rust. First I painted a layer of hammerite then fitted the gas dropout vents (rainbow conversions via eBay) into the holes with a liberal coating of exterior/interior sealant.
Once this was done, the remaining hole (16a underfloor socket to onboard consumer unit) was lined with 2 layers of cable conduit (vehicle wiring products) and the socket was attached.
More tomorrow
- Posted using BlogPress from my iPhone
Posts
